1. designed bookplate pattern scanning down with parchment paper. Tracing Use HB-2B pencil. (I like to use a 2B pencil, transfer more convenient time) if you are not good at painting can copy an existing picture. (You can print out the computer, but some people God is directly covered tablets and phones trace of) recall scaled according to the size of the stamp, simplifying overly complex lines.

2. Place the parchment paper that has a chart face down, covered in rubber, ruler and other things with a fingernail or gently scrape again. If the figure is large, you can tape the corners, to avoid moving. (Sulfuric acid paper is tracing paper, tracing when tracing paper can also be fixed with double-sided tape)

3. Press and hold the corner of the paper, exposing them to see if the transfer was clear. If they are missing, you can put down the paper, Zaigua about that place. (This step is very important, otherwise there will be printed map printed map incomplete and ambiguous situations.)

4. As long as the rubber surface smoothness clean enough, the picture can be transferred very clear. (In order to ensure clarity can use plastic rubber rubber brick dust surface to get clean and then printed.)

5. right hand corner knife, rubber left hand, gently rotate, carved circular outline. (Engraving posture is very important to pay attention to try to sit up, his hands held in front of elbows on the desktop, such as stable and not tired.)

6. round sliced unwanted places. Essentials above, it seems like Xiaoping Guo skin. This step, large utility knife can be done.

7. Start with a knife engraved outline. Close to the pencil line outwardly inclined pass, again from the opposite direction, to provoke unwanted debris. With a V-shaped groove completed two pen knife, knife, then with the angle can be done once, so the higher the efficiency of the corner knife. But most of the face and other details need to be patient with the graver complete.

8. place between unwanted contours gently dig up the horn knife. Be careful not to touch the line.

9. This is an even packed.

10. Likewise with the graver the spine to complete. (Novice corner knife can also be completed, taking into account the angle of the knife back into the knife shallow depth of case, you can do it again in the opposite direction angle knife handle, ending with a pen knife.)

11. do not need to dig up the place. Large area where you can use a knife to dig round

12. When most of the carving is done, you can take a look at the effect of a layer of inks. This moment has been completed and no place to clear out. Of course, if you are using a two-color rubber plate, you can save this step.

13. The text portion of a sum pick with the graver.

14. After completion engraved with plastic rubber stick out surface debris.

15. printed. The inks have to pat evenly on the surface of the rubber stamp.

16. India’s time to push hard moderation. But not too hard to avoid the rubber deformation.

17. A look at the results. The first test print, you might see some extra dots

18. do not need to dig up those places, if necessary, modify some of the details.

19. Thus, a rubber stamp bookplate on the well. Before switching to a different color inks, but also with a plastic eraser to clean it, printed it will not send dirty. It seems clean plastic rubber rubber stamp of essential supplies.

20. The results were pretty good.